Before every use:
#1. Thoroughly check your machine over and tighten any loose nuts, bolts and clamps as necessary.
Belt Sander
#2. Remove any dust and dirt or anything else caught in the cylinder head fins and engine block cooling fins.
#3. Look out for signs of any fuel leaks and fix them where necessary.
#4. Make absolutely sure that the throttle and choke levers work well and fix them if necessary.
#5. See that the cutting wheel does not move while the machine is left on idle. If it continues to rotate you must adjust the carburettor before further use.
#6. Inspect the cutting wheel and make sure it is top condition. You must not use a cutting wheel that has any cracks or chips in it.
#7. Make absolutely certain that the fuel is mixed exactly as recommended in the operator's manual.
Frequently:
#8. Inspect all air filter system components. Change or clean air cleaner parts exactly as recommended in your operators manual.
#9. Inspect the fuel filter for dirt and damage. If it's damaged in any way, replace it, if it's dirty then clean it.
#10. Ensure that the drive belt is correctly tensioned. When correctly adjusted the v-belt should be able to move between 5mm and 10mm with a little finger pressure.
#11. Inspect the spark plug. If it is fairly clean just check and adjust the electrode gap. If the plug is very dirty you must investigate the cause.
#12. Look inside the exhaust system and inspect the spark arrester, if it is blocked or missing you must fit a new spark arrester.
#13. Fully extend the starting cord and check for any signs of damage. If the cord is heavily worn then replace it as soon as possible.
Long term storage:
#14. Empty the fuel tank and clean it out.
#15. Start the engine and run it until it stalls to remove all the fuel from the carburettor.
#16. Take off the cutting disc then lightly attach the thrust washer and fixing bolt.
#17. Wipe the machine over to get rid of all dust and debris. Spray the machine with water dispersing oil for good measure.
#18. Ideally keep your TS410 in a sealed box or otherwise cover well with a suitable dust proof material.
#19. Keep your TS410 away from curious children!
#20. Keep your TS410 in a secure location away from prying eyes and light fingers!
Special Price!!! Rikon 50-150 Belt/Disc Sander, 1-Inch by 30-Inch
Click for larger image and other views
Rikon 50-150 Belt/Disc Sander, 1-Inch by 30-Inch Overview
RIKON introduces a new bench top combination sander to their lineup. Powerful 1/3 HP totally enclosed fan cooled motor spins the 5" disc at 3,450 RPM and the 1" x 30" belt at 3,340 SFPM for fast stock removal. The large 7- 1/4" x 3- 3/4" cast aluminum disc table tilts 0-45º. The belt table tilts for chisel sharpening. Removable belt platen allows sanding of curves or odd-shaped material. The solid steel base utilizes rubber feet and strong cast aluminum frame for minimal vibration and maximum rigidity. Includes two 1- 1/2" dust ports.SAVE NOW on the special offers below!
Available In Stock. |
| This Rikon 50-150 Belt/Disc Sander, 1-Inch by 30-Inch ships for FREE with Super Saver Shipping. |
Price : Click to Check Update Prices Please. |
